Automatic Hand-Wash Timer

by AIC Publications Admin July 21, 2022

According to the World Health Organization (WHO) guidelines, people need to wash their hands with soap and water at least for 20 seconds to get rid of any virus. Although you have a stopwatch on phones, wristwatches, and other electronic devices, it is not convenient to use them. Also, some people do not want to use their expensive phones near washbasins. So, it becomes difficult to keep a check on time for the handwashing procedure.

Fig. 1: Circuit diagram of automatic hand-wash timer

Here is a low-cost and simple solution that uses a timer at the heart of the circuit. NE555 timer is used in monostable mode along with an IR sensor to trigger it. The FC-51 IR sensor module has an inbuilt transmitter and receiver.

When you stand in front of the washbasin and place your hands near the IR sensor module, the sensor detects your hands. The detection makes the sensor to send a low pulse signal to pin 2 of the NE555 timer to trigger it. This activates NE555, and its output pin 3 goes high for 20 seconds. The flush LED1 connected to pin 3 of NE555 glows for 20 seconds. During this time, you can wash your hands until LED1 turns off. Also, a buzzer can be connected to pin 3 of IC1 for audio indication.

FIG. 2: Author’s prototype

A.I.C. Publications

Fig. 3: Prototype kept near the washbasin during hand-wash

The whole circuit can be assembled on a general-purpose PCB or veroboard. The author’s prototype assembled on the veroboard is shown in

Fig. 2. The prototype kept in a glass near the washbasin during hand-wash is shown in Fig. 3.

Shashank T.S. is an embedded engineer at Adappt Intelligence, Bengaluru. He has a keen interest in robotics and AI